3 replies to this topic

[walterww]

Hi,

 

I am new to the forum.

 

I have a problem where I don't see the full screen in VR.

 

For example, in the VR launcher 64-bit, I can only see partially the UI interface.

With great difficulty, I can shift something in game but,the settings are not saved.

 

Most of what I don't see is just outside the field of view. 

 

This also applies to the F11 function , the FPS tool.

 

I have tried windowed and full screen under graphics.Reset to defaults. Match te resolution with my monitor. Also shrink to fit (which I believe only affects the preview on the monitor and not VR). I saw these tips but don't see how this affects in VR.

 

I am using a Quest 3, Fpx 10.8( clean install via baller) and use Virtual Desktop.

Does somebody know what i do wrong?

[Emanoel299]

Hi

 

If you are talking about VPX launcher frontend too close your eyes:

 

Adjust VR Tweak Settings (Best Method)

 

While in the launcher, enter the tweak menu (often mapped to the "Add Credit" or F12 key).

Look for the "VR Tweak UI X/Y/Z" options.

Use the MagnaSave buttons to adjust the position and distance of the menu. 

 

If you are talking about in game view below my settings:

 

[walterww]

Thanks for your answer Emanoel,

I found at that changing te FOV settings to 80 procent ( in virtual streamer) has some impact. But VPX is becoming unstable with the settings.

They VPX Launcher is so far up in the screen that it is impossible to read. So changing it is not possible. The distance however is not the issue.
Even when i lower than the FOV settings to the lowest possibele, the settings info is way up and not readable.

I think i solved the issue.. I most first change the UI settings under F12.. I didn't see/understand that before.

Thanks for helping
 

Edited by walterww, 16 April 2026 - 01:26 AM.

[studlygoorite]

Thanks for your answer Emanoel,

I found at that changing te FOV settings to 80 procent ( in virtual streamer) has some impact. But VPX is becoming unstable with the settings.

They VPX Launcher is so far up in the screen that it is impossible to read. So changing it is not possible. The distance however is not the issue.
Even when i lower than the FOV settings to the lowest possibele, the settings info is way up and not readable.

I think i solved the issue.. I most first change the UI settings under F12.. I didn't see/understand that before.

Thanks for helping
 

Nice to see you solved it, if you have issues again make sure your VPX supersampling is disabled (100%) and if you can't see the F12 menu to adjust it's location in the VPX Launcher, then you can make changes to it without using the launcher by just launching a table through the GL64.exe and then it should be moved when you do go into the launcher. Hope that makes sense