4 replies to this topic

[Urko]

Trying to lower the volume of the three main bumpers, i have experimented with settings in the script  and in the sound manager,

but havent had any luck.

 

Any info appreciated, normally one of the two usually lowers the volume of table sounds.

[patroz]

Hi Urko,

try the following.... 

open and start the table that you want to edit.

When the DMD opens, touch it with the mouse to activate it. Press the key between ESC and Tab on the keyboard. Use all Courser buttons to adjust the volume.

Edited by patroz, 06 November 2023 - 08:36 PM.

[Urko]

Cheers for help but i have found out what was controlling the sound volume of the bumpers,

in the script there is a variable called BumperSoundFactor, which needed to be set low.

 

Usually altering in sound manager or the general volume in the script is enough.

If you are interested why i am so bothered about just the bumper volume on the table, im tuning up SSF 

to work with my solenoids, and on this table i find the bumper sound well ott, but i didnt want to decrease all the other sounds.

Edited by Urko, 06 November 2023 - 09:41 PM.

[patroz]

Otherwise you can exchange the sounds using the Sound Manager in Visual Pinball.

[Urko]

Otherwise you can exchange the sounds using the Sound Manager in Visual Pinball.

Good point i could always do that if needed, i overlooked that.