The UIO outputs are low power, about 20mA at 12V I think? I highly recommend just clicking my profile and just check my posts as I asked alot of questions on this and got alot of help. I'm a programmer at heart, not electrician 
I think it can do 12V bulbs, got some laying around, but eventually replaced them with LEDs to avoid overheating inside the actual buttons. Less heat. I wouldn't use the UIO outputs for flashers (which can take up over 350mA) or a LED beacon (which probably needs power for motor too?). So what you can do is use the UIO outputs as "trigger signals" to the SainSmart, and then have a SainSmart a single relay powered externally to for instance a flasher or say 24V contactor. Now multiply that with say 10 contactors and 1 set of flashers. Your 16-relay board still has available inputs/outputs. It isn't perfect, as the SainSmart introduces a ~100ms lag and just does on/off, but it's a start.
I highly recommend you start slow. For instance, just plug in your UIO and SainSmart USB (and nothing on it, just the device, USB connection, and power to it), go to configtool, setup up a SainSmart (left+right flippers, left and right slingshots), and see if you get anything. If you do, you know DOF and your table setup is running.
Then hook up a few LEDs to your UIO outputs, add an UIO to configtool, setup two outputs to say a left and right flippers, and try again. If that works, you'll know the UIO also works with DOF.
Two recommendations: 1) the UIO has a nice startup color output cycling, which means technically output cycling. It's cool for LEDs, but once you got your stuff connected it'll also trigger contactors, shakers, anything that the outputs are connected to. You can use one of the Ultimarc tools (winipac?) to set reset / blank that color cycling to none at boot / power on. And 2) the SainSmart 8 port USB also does this, except you can't turn off output cycling AND it does it 2 or three times. Maybe there's some way to update it or modify it, but right now I'm using the non-USB boards myself as they don't output cycle at poweron.
Edited by rambo3, 09 June 2017 - 06:33 AM.