6 replies to this topic

[bgood]

I like the new table startup videos, however I would like them to be full screen so if this is possible I need some help to make this happen. Ant help would be greatly appreciated.

 

Thanks

[fhjui]

To do this, the coordinates of the Standard PUP pack must be adjusted.

Open in Popper setup "Screens/Themes" for the loading screen (#7 here in my case), change the Custom-Pos. to "3,0,0,100,100". This means that the standard config has already been changed to full-screen.

It's described in my docu in chapter 25.8.7, link in my footer

[bgood]

fhjui: Thank you ever so much for this information.

[bgood]

fhjui:I have another question if you don't mind --- All the Info you passed on is great, can you explain how the co-ordinances work. Using yours places the loading screen in my upper right,my screen is 3840X 2160.Using the 3,71.875,0,28.125,100 the startups covered full width but only 1/5th height.Is there an equation i'm missing?

[fhjui]

oh, yes sorry. I have swapped the values in the picture of my docu, but the describing text was correct. As I described above You have to enter "3,0,0,100,100" in the PinUpMenu-PUPpack

meaning of the values:

1. 3: the screen# as listed in the puppack (3=playfield, 2=backglass etc.)

2. 0: Xpos offset according to the coordinates of the screen (here Playfield), "0" means no offset

3. 0: Ypos offset according to the coordinates of the screen (here Playfield),  "0" means no offset

4. 100: y-zoom in percent of the screen, "100" means 100% of the playfield

5. 100: x-zoom in percent of the screen, "100" means 100% of the playfield

 

with these values, the loading screen has the same dimensions as the playfield, its fullscreen

Edited by fhjui, 01 September 2024 - 11:01 PM.

[bgood]

Thank-you again I will try this tomorrow.

[bgood]

Worked Perfectly, again thanks for taking your time to help!

More Help see Link Below

Edited by bgood, 02 September 2024 - 03:27 PM.