Nicco84 - the photo is kind of dark but it looks about right. The Freescale is horizontal on the floor of the cab with screws through the screw holes in the board, right? And I assume you have some spacers underneath, and that the board is screwed down. Just to make sure, if you reach into the cab and try to jiggle the board manually, it feels securely attached to the cabinet and has no play at all, right?
You really shouldn't have to have much dead zone at all. To calibrate VP, I'd start by turning the dead zone off entirely (or down to zero), then turning the x and y gain down to the lowest level. At this point you really should see no motion at all even with a pretty hard nudge to the cabinet. If you're still seeing motion with small vibrations with those settings, there's something else wrong. If it does in fact get rid of all motion, you can start adjusting the gain upwards to find the right gain level. Again, do your adjustments with gain ONLY, keeping the dead zone at zero - it'll be too hard to separate the effects if you try to adjust both at the same time. Once you have the gain at a realistic level, THEN you can adjust the dead zone as needed to get rid of spurious jitter when the cabinet isn't being nudged.
When adjusting settings in
VP, remember that you have to close
VP completely - player AND editor - and relaunch
VP from Windows. Changes won't go into effect until you quit completely out of
VP and relaunch it.
If you can't get rid of the jitter by turning VP gain down to the lowest setting, the problem probably isn't in VP. The place to start in that case is probably the Windows control panel - bring up the adjustment page and look at the little crosshairs diagram. It will show you what the joystick interface from the Freescale board is reporting. You should see the crosshairs jittering around a very small amount when everything is at rest, and more when you nudge the cabinet, proportional to how hard a nudge you give it.
Edited by mjr, 13 February 2015 - 12:52 AM.