Pinball Fan
Posted 20 October 2014 - 12:04 AM
I have B2S Backglass server installed and set up to run on a single monitor, resized to fit into the top left of any desktop table, though I have a problem.
The B2S renders behind the desktop table, when I exit it appears for a moment, so I know it is being rendered. Is there anyway or trick to getting it to render on top or in front of the VP table?
Pinball Fan
Posted 20 October 2014 - 06:14 AM
With the older B2S this was not an issue?
Pinball Fan
Posted 28 October 2014 - 10:46 AM
So are we to assume there is no work around or remedy to utilise this "upgraded" software on a single monitor?
Posted 28 October 2014 - 01:38 PM
Best person to ask is Herweh - creator of B2S Server. Maybe you can try to PM him.
See if a utility like this works on it: http://www.labnol.or...ys-on-top/5213/
Pinball Fan
Posted 06 November 2014 - 06:51 AM
PM sent I tried the utility you reference, still no go.
Community Forum Software by IP.Board
Licensed to: VPForums.org
are all trademarks of VPFORUMS.
Top
Contributor