22 replies to this topic

[jpsalas]

UPDATE

 

5.5.1 Updated 23.05.2025

- Added DOF commands  by Urko

- Added more elasticity to the top EM rubber.

[Torch32]

I'm getting a pull on the ball as if the right side of the table is higher than the left side. kinda like the floor it sits on is not level

 

never mind, somethings happened and all my tables are tilting all of a sudden

Edited by Torch32, 23 May 2025 - 05:37 PM.

[jpsalas]

I'm getting a pull on the ball as if the right side of the table is higher than the left side. kinda like the floor it sits on is not level

 

never mind, somethings happened and all my tables are tilting all of a sudden

 

You have connected a game pad or similar and it is not calibrated for VPX. Do that in the VPX references, Key, Budge and DOF. Find the Dead Zone more or less in the middle of that window, and increase the value until the ball doesn't go anymore to the right. It is set at 0 by default. Just increase it 1 by 1 until it is ok. Or disconnect the controller if you don't use it