Jump to content



Photo
- - - - -

Arcade2TV-XR..... anyone elses unit incredibly SQUEAKY?


  • Please log in to reply
2 replies to this topic

#1 MudgeeWotto

MudgeeWotto

    Neophyte

  • Members
  • Pip
  • 4 posts

  • Flag: Australia

  • Favorite Pinball: TZ

Posted 22 August 2026 - 03:41 AM

Any owners here?

I've posted a short clip on YT of mine....it's always squeaked , but I've recently installed the haptics kit so I'm SLIGHTLY nudging it more often and the squeak is absolutely breaking my brain.

Yes I've lubed all contact points , put soft pads between certain joints etc, tried super tight screw and loose.... nothing changes it.

Here....
https://youtube.com/...0Ba2deMbnTU7-fB

#2 Breadbox64

Breadbox64

    Enthusiast

  • Members
  • PipPipPip
  • 122 posts
  • Location:Germany (Lower Sachsony/Niedersachen)

  • Flag: Germany

  • Favorite Pinball: The Addams Family, Former owner of TAF, TOM, WCS94, JB, JY, IJ, PF, RFM, AG Soccer Ball

Posted 23 August 2026 - 11:18 AM

Sorry I don't own this, but as a mechanic I do hope I can give you some help here. First of all you need to locate the exact source of the squeak. Then try to fixate the items enough to eleminate any movement between. If that won't be possible try to add some thin plastic between the moving parts, metal on metal tend to make noise, metal on plastic won't. Also not sure about what you mean by "I have lubed..." try to use grease rather than oil, because grease will stay in place much better than oil does. I do hope this will help you to eleminate the noise.


Edited by Breadbox64, 23 August 2026 - 11:20 AM.


#3 sixunone

sixunone

    Neophyte

  • Members
  • Pip
  • 1 posts

  • Flag: ---------

  • Favorite Pinball: indiana jones

Posted 08 September 2026 - 04:15 AM

Hi there,

To reduce the acrylic squeaking when launching or nudging in Pinball FX VR, please follow these steps:

  1. Loosen all 8 frame screws: the 4 side screws and 4 front screws (two of each on each upright). Loosen them only—do not remove them.

  2. Gently move the acrylic downward: hold it with both hands, one near each side, and gently wiggle it while pressing downward. This creates clearance between the acrylic and the upper light-strip mounting screws. Do not force or bend the acrylic.

  3. Retighten the screws: tighten all 4 side screws first, then all 4 front screws. Make sure the frame is secure without overtightening.

  4. Check the result: gently repeat the movement that caused the squeaking.

This adjustment should reduce the rubbing noise, although it may not eliminate it completely.