3 replies to this topic

[anthias]

Some of you might remember my VP 7 mahjongg table. I decided to port it into FP for no good reason.

This one is already largely complete, with sfx and some graphics stuff to go - table code complete and working well.

 

Give me a bit of time, and I might just finish it off!

Attached Files

•  fpmjss.jpg   356.87KB   1 downloads

[GeorgeH]

You might want to try adding physics using my guide at this link:

 

https://pinballnirva...-physics.20001/

[anthias]

Thanks GeorgeH! I have placed your physics xml into this table and it works a treat! (I had the table slope at 8 and had to lower it, the stdm problem was savage with the physics changed but OK once lowered to 6.8.) It does make the table much more difficult, but that's not necessarily a bad thing.

Will the table still run without BAM or would I need to release a seperate non bam table for FP vanilla folks?

Edited by anthias, 30 June 2021 - 12:39 PM.

[anthias]

just about done.

 

 mjfp1ss.jpg   168.11KB   1 downloads