4 replies to this topic

[destruk]

Lady Luck [16:9]



Version: 1.0.0
Category: VP 9.x Cabinet Tables (SPANNED)

Author(s):

Description:
VP9.x 1360x1536x32 Vertical Span
Author(s):
Original table by Destruk, 16:9 Conversion maintainer Destruk

View File

Submitted by destruk, on Feb 3 2009, 06:41 AM

Edited by destruk, 22 February 2009 - 09:45 AM.

[dizzy33]

Thanks a lot for this table, but I am searching for a "Full Screen" release of this table for use in a cabinet. Can you create the same table but with no backglass on the left ?

Thanks !

[xenonph]

You can adjust this table to where only the table is showing. I fooled around with the settings and this seems closest to fitting screen right, without showing backglass.

 

After the table is loaded into VP editor,

With the Backdrop and Options tab pressed down on left side of editor, click Colors & Formatting on right side of editor.

 

Change the numbers to these...

 

Inclination                         45

Field of View                     0

Layback                            0

XY Rotation                      270

X Scale                             2.71

Y Scale                             3            <-----------change

Z Scale                             1        

X Offset                           -1450      <-----------change

Y Offset                            746

Z Offset                            0

 

This fills the screen with only the table.

You can adjust better if you want.

The pinball wouldn't go through gate at top of pinball launch (Think that problem was already there or maybe its just on my computer.)

So with Options Tab pressed down on left side of editor, and backdrop not pressed down, move the picture of pinball table until you can see upper part of table and click where the gate is that is blocking the ball from going into playfield.

Left Click on the gate (It will now say Gate on right side of VP Editor)

Click Position.

Change Length to 119

The Pinball should now pass through gate properly.

 

Voila!! FS TABLE WITHOUT SHOWING BACKGLASS!!!

Be sure to save table after editing and keep copy of original table if needed.

 

And if you will be using dB2S Backglass program,

Here is link to Backglass...http://www.vpforums....s&showfile=9007

Hope this helps.

Edited by xenonph, 23 December 2015 - 12:37 PM.

[dizzy33]

thanks a millions !!! it works great, thanks a lot for your help !!!

[xenonph]

You are welcome!!!

Keep on Pinballin'