No replies to this topic

[jtarmada]

So I built complete set of DIY Pinscape Pico boards. Not my first PCB project but for some reason when configuring DOF, as soon as solenoids should fire, the PWMWorker stops flashing and I have to reset main board to get it functioning. The Pico Main still runs before resetting the PWMWorker. Any thoughts? Currently only running the Main board without the Power Board. Running 8 24v AC solenoids at 12v with diodes stripe on positive. Less than 2 amp current draw on each channel. Also if using DOF, do you leave the configuration template for the DIY expansion board outputs alone and let the DOF Config control them? Have not been successful on the DOF side at all yet. Been running buttons only for about 3 months.