1 reply to this topic

[Smackx]

In the Doflinx config file we assign a default L_Flipper and R_Flipper key (A0,A1) as well as the output solenoid ( 1001, 1005 ).  So isnt this suppose to fire my solenoids if I press left shift or right shift while playing a Pinball M table since its not recognized under PROCESS= ?

I dont understand the whole 'default' key bindings to output section of the config file as it pertains to setting up the left and right flippers to my solenoids.  I thought if Doflinx couldnt find DOF for the table then it defaults to these assignments.

 

Bottom line - I am just trying to get basic flipper force feedback for the Pinball M tables.

 

Thanks!

 

Bonus Question:  Why do I see two variations of port assignments such as 101 and 1001 ( device 1 , port 1 ) ??

[Derrickolf]

Hi Hobbyist!

 

I think you should understand some basic issues like:

 

If DOF has no data for that table, Doflinx will rely on the default values ​​you manually assigned as above. That's why you can still get feedback if configured correctly.

 

The solution is you can create basic force feedback with a few lines of correct configuration as above, no need for full DOF for Pinball M.

 

Thanks!

 

 By: Neophyte, Poor Bunny

Edited by Derrickolf, 10 July 2025 - 04:18 AM.