5 replies to this topic

[Friedi1987]

Hey there,

 

I just tried out the VP 10.8 pov settings via ini files.

Started the table with F6 adjusted settings and hit 1. So far so good. First time doing this really seems to save the settings and running the table again with the ini file among the table files uses these settings.

But if there is a table ini file existing already changes made will not be applied.

E.g Table started with F6 -> adjusted settings -> stored with 1/start game relaunch with F5 works but if you notice you want to readjust one setting and save ini again it does not save the settings.

 

Is there a known issue about that?

 

Best regards

Friedi

[Thalamus]

Not that I know of. I have all my tables in the cab now using that feature. I make sure to press the '1' when I'm in the section that I want to change though, because I noticed that if I changed "POV", then went over to tonemapper and changed that too before pressing the '1'. Table would take the tone mapper changes but not save the pov. So, I normally press '1' 2 times pr. table because I like my tables a bit darker now that I've changed over to a OLED.

[Emanoel299]

Hi

 

You need to press "1" in each page that you did some change.

[Friedi1987]

Hey there,

 

thank you for your replies.

That was indeed the problem. Went to another page and did not press 1 on the page i did chages to.

 

Thanks a lot

[lordraiden128]

Thank you. This has been driving me nuts for weeks!

[Lom87]

Thank you. This has been driving me nuts for weeks!

woow, me two for about a year or so….