1 reply to this topic

[goodtwist]

I'm placing the settings that worked for me that smoothed out the ball flicker or slightly stuttering. My playfield is a 4K LG43UP76 set to game mode. Max refresh is 60Hz. The computer is a Dell 7050 (2018) with a 1050Ti 32G Ram. It's the highest GPU that I could get. I'm using 3 screens with a full DMD.

 

The important one that worked for me was setting the nvidia graphics card to slightly less that 58 FPS. Setting "Low Latency Mode" helped with the response time of the paddles. I started by setting to "High End PC" and dialed back things back. The changes I fussed with are highlighted in yellow.

 

 

Better image hosted on google site: https://sites.google...pinballsettings

 

If anyone sees something that I might should change, please let me know. I may start increasing some of the settings, since I lowered them to troubleshoot the ball issue.

 

Thanks to this thread for the Max frame rate tip!

https://www.vpforums...ic=45098&page=2

 

[flstclasic]

What are your thoughts on turning Nvidia low latency on? Any improvement? Any reason to leave it turned off? I turned it on in my cab and did not notice a difference in the two tables I tested.