9 replies to this topic

[jwosi]

I have a virtuapin v3 controller. Within the controller software, nudge and tilt register and the lights goes off on the controller itself. However, VPX doesn't seem to register the movement. I just noticed on VPX 10.6 final it's not working. I know it was working on 10.5 and earlier 10.6 beta versions. Any ideas would be great. Thanks.

[Badazzwi]

Check to make sure nudge is enabled under keys,nudge and dof preferences. Maybe it got reset somehow.

[jwosi]

It is enabled and doesn't respond.

Thanks

[Thalamus]

It is definitely not related to 10.6 - I just tilted a great game. Run DXView - be sure that shaking is sent to DirectX.

[jwosi]

I'm not familiar with DXView.

[Thalamus]

Ups. Meant DiView.

[jwosi]

It does register in DiView

[Thalamus]

Long thread - but, you should learn a few things. https://www.vpforums...ic=33287&page=1

 

... few more tips here too : https://vpinball.com...knowledge-base/

[Bushav]

Manuall bump the actual circuit board while cradling ball in flipper. Do this after a cold restart in case the usb has disconnected during game play. My virtuapin occasionally disconnects electronically while playing.

A manual bump will make sure your sensitivity settings arent the culprit.

[jwosi]

I had x-max and y-max values missing. The directions don't show needing those values. I just need to understand better the max and gains and play with the values. Thanks

Edited by jwosi, 23 December 2019 - 11:33 PM.