1 reply to this topic

[waltiti]

Hi guys,

 

I ready to start the cab, but I have a confusion with too much information. i know the best option is Pinscape V2 or ... ?

 

I just want that all the 20 buttons I will add to my cab be readed by my PC and ...

 

* a good realistic Nudge, I think is built in the pinscape v2

* a Plunger, I think is built in the pinscape v2 and can use any analog plunger, any recommendation? 

* and a Shaker, how to make it work?

 

I see a guy that have Vpin cab for sale on facebook that he say use a pinscape, a 12 volt dc power supply, a potentiometer, and a motor to have nudge, plunger and shaker (motor)

 

I plan to use PMS with exiters. 

 

Can some one guide me to buy and setup this; or there is guide that help to buy, wire and config this parts. ???

 

Where to buy the pinscape, I think is around $15-$20uss ?

 

Thanks

Walt

Edited by waltiti, 30 October 2019 - 04:08 PM.

[JLPicard001]

I assume you've found this from MJR?  

 

http://mjrnet.org/pi...ver=R3.201602xx

 

The 'pinscape' is MJ's software, it runs on the microcontroller (explained on the above document) KL25Z.  You can buy them in different places just google it.  Start with the basics is my suggestion then add your 'toys' as you get the system going.  Exciters, shakers, etc., Add them after you get the basic cabinet, microcontroller of your choice (KL25Z is mine), and the associated software.  There's a ton of good builds shown on these pages.