5 replies to this topic

[Mandolin]

Hi, I am making an apron but I don't have a real Williams/Bally pinball and I can't find plans for this. Do you think these are near good? I don't need it to be perfect, but very close to the original. Thank you.

 

 

In inches, this is 8,85" the left and 18,83" the base. I made this based in the width of the Bally standard lockbar, and drawing and scaling the plans from the Medieval Madness Remake playfield.

 

 

 

Thanks

Edited by Mandolin, 07 April 2019 - 07:21 PM.

[jesperpark]

Width your showing should be 18.25" wide.  I have a MMr that I can measure whatever you just need to grab a metric tape measure and pull the glass, will be tomorrow though.

[Mandolin]

Width your showing should be 18.25" wide.  I have a MMr that I can measure whatever you just need to grab a metric tape measure and pull the glass, will be tomorrow though.

 

Thank you, don't need to pull the glass, just over the glass if you want.

[jesperpark]

Okay so the dimensions you have labelled the actual width is 458mm and the height is 212mm.

[Mandolin]

Okay so the dimensions you have labelled the actual width is 458mm and the height is 212mm.

 

Very very kind of you, thank you sir.

[jdv]

Thank you - this helped me too!