Jump to content



Photo
- - - - -

ledwiz wiring


  • Please log in to reply
3 replies to this topic

#1 djhamp

djhamp

    Enthusiast

  • Members
  • PipPipPip
  • 50 posts

  • Flag: ---------

  • Favorite Pinball: star trek

Posted 12 May 2015 - 01:14 AM

I know there is a a lot of info out there on this but that's my problem, seeing so many different ways of doing things! i am getting ready to wire up lights and contactors and saw this diagram which looks easy to understand - is this right? I have 5 12v starter solenoids and 5 24v siemens contactors, a 12v & 24v power supply, 5 rgb flasher leds plus the button leds. I know I need the diodes, fuses, resisters that are not showing.

wiring.jpg

#2 zebulon

zebulon

    Cantankerous old B****D

  • Platinum Supporter
  • 1,179 posts
  • Location:Whitby, Ontario, Canada

  • Flag: Canada

  • Favorite Pinball: xenon, Medieval Madness, Royal Flush, Silverball Mania

Posted 12 May 2015 - 11:55 AM

You have it right.  As you said, you'll need diodes and resistors.

 

You'll likely also need relays or a booster for the 5 x starter solenoids depending on the draw.

 

The important wire run is the ground wire to the ground input terminal on the ledwiz to ensure that you have a good path to a common ground point with the power supplies.  Without that you'd be sinking every output to the ground on the usb port which would cause all kinds of issues (like the ledwiz disconnecting and possible damage to the usb port from residual voltage).

 

Looks like you have a good start there.


 ZB%20%20Storefront1%20.png               [email protected]

Don't pm or expect an answer from me here ... the links above are my contacts.

I know so much about so little that I could teach you all there is to know about nothing......


#3 djhamp

djhamp

    Enthusiast

  • Members
  • PipPipPip
  • 50 posts

  • Flag: ---------

  • Favorite Pinball: star trek

Posted 12 May 2015 - 02:53 PM

Thanks for that! I do have an sainsmart 16 channel relay module I can throw in the mix. I really wanted to buy your booster board - had it in the cart but the shipping threw me off (I know that not your fault!)



#4 zebulon

zebulon

    Cantankerous old B****D

  • Platinum Supporter
  • 1,179 posts
  • Location:Whitby, Ontario, Canada

  • Flag: Canada

  • Favorite Pinball: xenon, Medieval Madness, Royal Flush, Silverball Mania

Posted 12 May 2015 - 03:13 PM

The shipping calculator is pretty basic and tends to err on the high side.  Extra shipping charges are always refunded at the time of shipping...:)

 

Anyway, good luck with your build!!


 ZB%20%20Storefront1%20.png               [email protected]

Don't pm or expect an answer from me here ... the links above are my contacts.

I know so much about so little that I could teach you all there is to know about nothing......