4 replies to this topic

[trnk31]

Hey guys hoping you will be able to guide me here. I have my cab built and am running mostly FP tables with the BAM setup. All of that works well and I didnt have any trouble up until I decided a real dmd would be 1000 times cooler than just my backbox haha. I think I have everything where it should be as far as the .dll and .txt files in regards to FP; I know I have the usb driver installed correctly because it works with my VP tables perfectly. When I load FP the display shows the interceptor screen (V. 1. 02. 2013) so I am assuming that is working as well. Problem comes in when I load a table the display never moves off of the interceptor screen (i've tried "ledwiz" modded tables with same result). I attached the gliLog.txt after I tried an addams family ledwiz modded table. I have to be missing something here, any help is greatly appreciated!

 

Thanks,

 

-Trnk31

[gimli246]

Does it have to do with the resolution of the DMD  ie Future DMD must have 128 x 32 I think, not sure about a real DMD it might b 128 x16 ?

[trnk31]

Thanks for the response! Everything I've read says the pinDMD2 should pick up the first 128x32 drawn by FP.

[gimli246]

Did you solve this?
If not check out jasonsmith tutorial
at gopinball

http://www.gopinball...e=1&f=55&t=2919

Edited by gimli246, 05 November 2014 - 02:15 PM.

[trnk31]

I have not, haven't had allot of time to dedicate to it with work the past couple weeks. I will definitely give that tutorial a shot when I get a chance. Thanks for the help!