No replies to this topic

[Flipouille]

Hi everyone,

 

I'm just starting on the whole virtual pinball world, so bear with me.

 

Last week I installed everything as per tehkgeek videos on youtube (for Virtual Pinball and Hyperpin). I also installed FPlaunch whic hmakes it a lot better for loading the tables and exiting and the whole lot. And everything was working fine.

 

Then I tried to install the ACDC table which features a direct B2S backglass.

 

And I messed up everything apparently.

 

The B2S backglass isn't working - or when it appears it's only partial and on the wrong screen (the one dedicated for the DMD - yes, I forgot to say that I've got a 3 screens setup), but I must admit that I haven't read everything posted on the subject yet. So I'll be trying to sort this issue out this week-end.

 

FPlaunch is where I need some help. Hyperpin isn't launching FPlaunch when I select a table and freezes upon the table selection. But FPlaunch is working until I select a table (if I press "Esc" after opening Hyperpin, I've got  the menu "Back to game / Exit Hyperpin / Shutdown Computer").

FPlaunch is working because if I start it outside of Hyperpin, I can select a table, it loads the "please wait picture", loads the table and exits properly once I'm done.

 

Can someone help me on how to get FPlaunch to work again to load my tables so Hyperpin doesn't freezes and I get the neat interface from FPlaunch ?

 

Thanks everyone