Jump to content



Photo
- - - - -

OptimusPin My Pin2K Cabinet


  • Please log in to reply
1 reply to this topic

#1 ViriiGuy

ViriiGuy

    Enthusiast

  • Members
  • PipPipPip
  • 126 posts
  • Location:Knoxville TN

  • Flag: United States of America

  • Favorite Pinball: Pinbot, Indiana Jones, Adams Family

Posted 27 May 2013 - 09:50 PM

Hello everyone,

I have a build thread elsewhere and I know some of you have seen it, But now that my cabinet is complete, I thought I would share a few pictures and video with you all!

I had MameMan make a Pinball 2000 cabinet for me and ship it to me, flat packed. The cabinet was pretty much perfect!

 

I then enlisted a VERY talented artist named Javier Reyes @ http:\\www.javierreyesart.com , who has worked with IDW on the Transformers Comics, to draw up some custom artwork for my cabinet.. Toss in all the bells and whistles... 8 Contactors, Replay Knocker, Shaker motor, Wiper motor, 2 strobes, 5 RGBFlashers, RGB Flipper buttons and RBG Undercab lighting... and you wind up with what I have now...

 

I give to you, OptimusPin...

 

 

This is a Video of the Attract mode...

 

And here are some shots of the artwork...

DSCN2473_zps93ff71ec.jpg

 

DSCN2472_zps8b6ed8ec.jpg

 

DSCN2469_zps6a6ce142.jpg

 

DSCN2468_zpsc44e9e43.jpg

 

And of coarse what Transformers cabinet would be complete without a Matrix of Leadership as the topper...

328c9061-8d5c-4c6a-9a02-4193ca5dcb38_zps

 

The Launch button says Roll Out and all three buttons are done in the Transformers Font.

 

It has been an interesting build, with lots of oddities and blown electronics... But I am happy to say it is now complete...... Or is it?

 

:)

 

Thanks for looking! There are a couple more videos on my youtube page if anyone is interested.



#2 ViriiGuy

ViriiGuy

    Enthusiast

  • Members
  • PipPipPip
  • 126 posts
  • Location:Knoxville TN

  • Flag: United States of America

  • Favorite Pinball: Pinbot, Indiana Jones, Adams Family

Posted 20 October 2026 - 03:21 PM

Well, it has been 13 years since I built this and 7 since it was playable. Not too long after I opened my Pinball repair business, this cabinet lost a screen. Then the hard drive and then the video card. After that, it fell by the side, while I focused on building my business.

But now, its time to resurrect it and modernize it a bit! Im hunting for a 4k screen I can squeeze into my cabinet, I have an Alienware to put in for the PC and Im planning to add SSF to my feedback stuff, once I have it operational again.

Does anyone have any tips for finding a 4k 120 hertz screen or better, that will fit inside a standard width cabinet?