25 replies to this topic

[Benoit33]

 

hello and congratulations on your work.

can we add 74hc165 to add MPU-6050 input for the accelerometer and PCA9685 for 16 output. for example

https://github.com/p...l-pinball-board

Edited by Benoit33, 02 April 2024 - 01:48 PM.

[lololol]

Good morning. does it work like a leswiz or kl25z? I please need to operate 10 contactors. knocker shaker gear. Does it work well as a pinscape? THANKS you know that we can't find a KL25z on sale.

[digitalarts]

It's a "ledwiz clone" - so it works as a ledwiz
And don't forget: always power your toys through a separate PSU!

Edited by digitalarts, 10 April 2024 - 04:47 PM.

[lololol]

Good,

its working like kl25z NUDGE and plunger? potentiometer 10K OHm

[digitalarts]

do you know a "ledwiz" ?

like the original, this arduino based clone has OUTPUTS. Digital PMW outputs. Nothing more, nothing less.

NO accelerator for nudging, NO analog input for plunger poti 

 

(of course, this could be done, but not with THIS script, and only with additional hardware)

 

I think what you search for, is a complete replacement for kl25z/pinscape. So search for Arnoz "Dude's Cab" hardware

[machineboy]

First of all, thanks to Kodel for making this available.

 

I'm trying to convert an Arduino Leonardo to a LedWiz, but has not been successful so far. I have followed the steps here, and have previously programmed this device to act as an xbox controller so the bootloader should be ok. The pins and cpu should be the same as the pro micro, so I was hoping it would be possible to reuse this board.

 

However I get the Unknown USB device after the project has been uploaded. I'm still fairly new to Arduino programming, but if anyone has done this with a Leonardo unit I would be grateful for any more information on what to try to make it work.

 

Or should I just order a Pro Micro board and try that instead?