64 replies to this topic

[Carny_Priest]

Sorry, the link was deeper in the thread:

 

https://vpuniverse.c...t&comment=62343

 

Might be official patches for CD media. You should be able to run your version of the GOG without the pincabview launcher if only to see what the revision number is. It will be displayed on the game's DMD display when it "boots" up for a simulation.

[mlevant1965]

I'm not sure where to go or what I'm doing wrong. I got ProPinball BRUSA working, but I can't seem to get the full DMD on my third screen. It says it should already work but it's not recognizing my third screen, but VPX is working fine

Something in the ini on cab view or reshade? Definitely could use some help. Thank you

[Carny_Priest]

Using a supported version of BRUSA?

 

Windows DPI scale the same for all three screens?

 

Open the ini in a text editor and read the comments. There are ini values that you can type into the file to "hard code" the location and dimensions of your DMD screen in your specific setup.

 

The official support forum thread is linked in the original post. Might be an answer there too.

[mlevant1965]

Using a supported version of BRUSA?
 
Windows DPI scale the same for all three screens?
 
Open the ini in a text editor and read the comments. There are ini values that you can type into the file to "hard code" the location and dimensions of your DMD screen in your specific setup.
 
The official support forum thread is linked in the original post. Might be an answer there too.

Yes. I purchased my version from GOG. All my screens are set at 100%. I went through the pincabview ini and reshade ini, unfortunately I'm not sure what to hard code. I'll recheck the original post

[mllkat]

Thank you for this fantastic software. Works very well with all three GOG versions of Pro Pinball. I only wish there was a way to mirror the DMD to my PinDMD3. Is that even possible or has anyone accomplished this?