Balls per Game Adjustment - Williams System 8

Here is the procedure to set number of innings on Williams System 8 tables:

1. Press 9 to enter diagnostic mode. The displays should go blank when you enter this mode.

2. Press 8 to enter test mode.

3. Press 7 and then press 8 to see 00 in the innings display and 4 in the outs display.

4. Continue to press 8 until you see 04 in the outs display and 30 in the innings display.

5. Press and hold the 1 key to select the number of innings you want. Value will increment by 1 while you are holding in the 1 key. When you reach the number of innings you want to set it to, release the 1 key. (NOTE: If you want to lower the value for the number of innings, or if you pass the value you wanted, release the 1 key, press and release the 7 key and then press and hold the 1 key. The value will then decrement by 1 while you are holding in the 1 key)

6. Press F3 to save your changes and reset the table.

This procedure should work for the following tables:

Williams System 8 tables:

Pennant Fever