Here is the procedure to set number of balls on Williams System 6A tables:
1. Press 9 to enter diagnostic mode. The displays should go blank when this key is pressed.
2. Press 8 to enter test mode.
3. Press 7 then press 8 to see 01 in the credit display.
4. Continue to press 8 until you see 04 in the credit display and 30 in the match/ball in play display.
5. Press and hold the 1 key select the number of balls you want. The value will increment by 1 while holding in the 1 key. When you reach the number of balls you want to set it to, release the 1 key. (NOTE: If you want to lower the value or you went past the value you wanted to set it to, release the 1 key, press and release the 7 key, then press and hold the 1 key. Value should then decrement by 1)
6. Press F3 to save your changes and reset the table.
This procedure should work on the following tables:
Williams System 6A tables:
Algar, Alien Poker
1. Press 9 to enter diagnostic mode. The displays should go blank when this key is pressed.
2. Press 8 to enter test mode.
3. Press 7 then press 8 to see 01 in the credit display.
4. Continue to press 8 until you see 04 in the credit display and 30 in the match/ball in play display.
5. Press and hold the 1 key select the number of balls you want. The value will increment by 1 while holding in the 1 key. When you reach the number of balls you want to set it to, release the 1 key. (NOTE: If you want to lower the value or you went past the value you wanted to set it to, release the 1 key, press and release the 7 key, then press and hold the 1 key. Value should then decrement by 1)
6. Press F3 to save your changes and reset the table.
This procedure should work on the following tables:
Williams System 6A tables:
Algar, Alien Poker