Jump to content



Tutorial info Visit support topic

  • Added on: Apr 16 2013 07:16 PM
  • Views: 4341
 


* * * * *
1 Ratings

Balls per Game Adjustment - Williams System 6

Procedure to adjust number of balls per game on Williams System 6 tables

Posted by ta2686 on Apr 16 2013 07:16 PM
Here is the procedure used to set number of balls on Williams System 6 tables:

1. Press 9 to enter diagnostic mode. The displays should go blank when this key is pressed.

2. Press 8 to enter test mode.

3. Press 7 then press 8 to see 01 in the credit display.

4. Continue to press 8 until you see 04 in the credit display and 30 in the match/ball in play display.

5. Press and hold the 1 key to select the number of balls you want. Value will increment by 1 while holding in the 1 key. When you reach the number of balls you want, release the 1 key. (NOTE: If you want to lower the value or you went past the value you wanted to set it to, release the 1 key, press and release the 7 key, then press and hold the 1 key. Value should then decrement by 1)

6. Press F3 to save your changes and reset the table.

This procedure should work on the following tables:

Williams System 6 tables:

Tri Zone, Time Warp, Gorgar, Laser Ball, Firepower, Blackout, Scorpion

This procedure also works on the following System 4 tables:

Flash, Stellar Wars*

This procedure should also work for Geiger table Dino Turbo (conversion kit)

*- for this table, in step 4 press the 8 key until you see 04 in the credit display and 31 in the match/ball in play display