Replay Adjustment - Williams System 8

Here is the procedure to change the replay levels on Williams System 8 tables:
 
1. Press 9 to enter diagnostic mode. The displays should go blank when you enter this mode.
 
2. Press 8 to enter test mode.
 
3. Press 7 and then press 8 to see 00 in the innings display and 4 in the outs display.
 
4. Continue to press 8 until you see 04 in the outs display and 13 in the innings display.
 
5. Press and hold the 1 key to change the high score to date. Score will increment by 10 runs while you are holding in the 1 key. When you reach the score you want to set it to, release the 1 key. (NOTE: If you want to lower the value in the high score to date, or if you pass the value you wanted, release the 1 key, press and release the 7 key and then press and hold the 1 key. The score will then decrement by 10 runs while you are holding in the 1 key)
 
6. Press 8 to see 14 in the innings display. Note that if you had pressed the 7 key in the previous step, you will need to press the 7 key before pressing the 8 key, otherwise you will go to the previous setting.
 
7. Repeat step 5 to change the first replay level.
 
8. Press 8 to see 15 in the innings display.
 
9. Repeat step 5 to change the second replay level.
 
10. Press 8 to see 16 in the innings display.
 
11. Repeat step 5 to change the third replay level.
 
12. Press 8 to see 17 in the innings display
 
13. Repeat step 5 to change the fourth replay level.
 
14. Press F3 to save your changes and reset the table. (NOTE: If you want to reset the high score to date to the value you set in option 13, press the 6 key while in attract mode,)
 
 
(NOTE: If you want to disable any of the replay levels in options 14-17. set that option to zero.)
 
This procedure should work for the following tables:
 
Williams System 8 tables:
 
Pennant Fever