10 replies to this topic

[Slydog43]

Does anyone have vpinmame.dll version 2.9 working without issues with a pinDMD3 display.  I have some games where the DMD is messed up.  It will pause and stutter and then show some garbage.  I think there are some good improvements in 2.9 so I would like to be able to run it.  Thanks

[toxie]

hmmm.. please contact lucky1 about this.. he's maintaining the external device dlls.. unfortunately i cannot as i chose a monitor as DMD..

[Thalamus]

Yes my friend. I don't have any problems currently. Well, except that I can't write my highscore on Diablo UltraDMD :-)

Edited by Thalamus, 18 April 2017 - 08:05 PM.

[Koplings]

did you ever get this figured out?  I am using pindmd3 - 2.7 and 2.8b work great but with 2.9 I get dmd flickering etc.  sounds like the same problem you have.

[Slydog43]

I did, I think my trouble was that I was using an older version of pindmd.dll.  I had that exact issue, check your pindmd.dll and make sure its current.  sorry not in front of the cab now to tell you which version.  Post if your still having trouble and I can try to help, 

[Koplings]

ok thanks.  the vpinmame.dll i'm using says 2.9.0.0.  Is there a  more current one than that I should be getting somewhere?

 

thanks for your help.....ive been fiddling with this for awhile trying to figure it out....

 

thanks for your help

[Koplings]

solved it with thanks to slydog43.  I wasn't using the most current dll.  works like a charm now.  thanks!

[Koolywiz]

Sticking with 2.8 and vp10.2 for now, everything is working perfectly.

Edited by Koolywiz, 13 May 2017 - 01:59 AM.

[Rotrax]

Sticking with 2.8 and vp10.2 for now, everything is working perfectly.

 

had the same issues. also back to this configuration and working great.

[Koplings]

well I needed 2.9 in order to play monsterbashs' newest pincab tables.  they are worth upgrading to 2.9 and wont play on 2.8 or 2.8b so it was worth it for me.  getting the proper dll for 2.9 solved the problem for me and it was worth it to have access to these tables

 

once I had the correct 2.9dll it works as well as 2.8 and allowed me access to more tables

[Slydog43]

I just reinstalled a Pincab because it was just time and I had some PinDMD3 troubles.  Fresh install of win10x64, installed 10.3 and 10.3.1. minimal copy over.  Move PinDMD3 stuff and tried out a table.  Damm display is slow and sometimes shows garbage.  This is so strange as I just did another machine last week and it went well.  UltraDMD just freezes VPX.  ahhhh I hate computers sometimes.

 

It was of course very simple.  Wrong dmddevice.dll again

Edited by Slydog43, 27 July 2017 - 02:59 AM.