1 reply to this topic

[drhotwing]

Greetings all, 

 

OK, starting to get back into Future Pinball after a couple of years with the awesome VR capabilities thanks to BAM. I'm realizing that the default gameroom textures are horrible in VR. I've tried just about everything I can to add my own custom wall and floor textures but I can't seem to get it right. 

 

I've followed the very few tutorials on how to do this and I've had no success. Here's what I've done so far

 

I turned off the render gameroom in the settings

Used the template that I found in a tutorial on a different site

imported my custom texture

added an ornament to the table in the position noted to place it in a forum thread on here

then selected the new texture from the dropdown of the new ornament.

 

I've tried to move it around probably 100 different locations now but never see the new texture, only see the black room.

 

Is there anyone here that could help me out with this as after spending probably 7 hours total on trying to get this to work I'm getting a bit frustrated. 

 

Any assistance here would be greatly appreciated.

 

Thank you

 

Jeff

 

[gimli246]

check out this thread :

http://www.gopinball...&p=84098#p84098

 

You can PM me at Go pinball and if you send your table, I can help...

 

There numerous ways to change the games room floor and walls especially if you use BAM.

Edited by gimli246, 02 November 2017 - 08:10 PM.