105 replies to this topic

[jwosi]

How do I get the DMD to always play on my pindmd3 all the time? If I run ultradmd.exe  /c and select a random size, the game will run once on my real dmd and hide the one over the table. the next time I launch the game, no realdmd and back the one over the playfield.

Edited by jwosi, 28 October 2017 - 03:07 AM.

[Thalamus]

http://vpinball.com/...-dmddevice-dll/

 

I highly recommend that you follow my guide. Easy to revert if you don't like it.

Edited by Thalamus, 28 October 2017 - 07:51 AM.

[jwosi]

When I start the table from pinballx, focus moves off the playfield and I'm unable to play the game unless I alt+tab back to the playfield.

[Spitfire]

Download the latest version of Stranger Things V2.2 MX DOF.

all loads and works as it should however once I start the game and hit the flipper buttons, I get the error in script,

bcright variable not found and directs me to the line in the script.

I have the latest version of Dof Config and the latest version of VPX 10.4

what am I missing?

[TerryRed]

Download the latest version of Stranger Things V2.2 MX DOF.

all loads and works as it should however once I start the game and hit the flipper buttons, I get the error in script,

bcright variable not found and directs me to the line in the script.

I have the latest version of Dof Config and the latest version of VPX 10.4

what am I missing?

 

This was my fault...I forgot to remove the last of the manual ball control portions in the "KEYS" section of the script (when I added the MX mod). If you use "C" for your flippers than this will cause the table to give that error.

 

 

Just goto the KEYS section in the script and either remove the manual ball controller portion, or change its key to something that you don't use.

 

 

Again...sorry about that guys.

[twowarps]

TerryRed,

 

Total noob here, having the same problem with the flippers causing the game to immediately crash. I have tried different edits to the script including deleting the section in asterisks around "manual ball control", and changing those values. So far my outcomes have been either no change or rendering the plunger useless. If you could show the exact lines to delete it would be a life saver. Im hoping to show the table off in the cab tonight!!

 

Im just not sure the exact lines to delete and Im a few hours in to experimenting.

Edited by twowarps, 19 November 2017 - 06:29 PM.